high temperature wear resistant ceramic tile epoxy adhesive
BD241 high temperature anti abrasion wear resistant cermaic tile
bonding repair epoxy adhesives:
Invention Patent No.:
200510064703.1 ( Patent Certificate for your reference )
Two component,30Kg/group(A component:20Kg,B component:10Kg),packed
in a plastic drum.
It's consist of modified toughening heat resistant resin and the
special curing agent
Aging resistant,high temperature resistant,good toughness.
Can cure at room temperature,can also heat for curing.
The highest working temperature is 240℃,when it is used as the
repair agent.The highest working temperature is 220℃,when it is
used as the structural bonding.
With high bonding strength and good toughness,suitable for the
bonding of metal,ceramic,cement and glass.Used in the bonding of
wear resistant ceramic chip under 220℃ working condition,also used
in the bonding and repairing of machine part under high temperature
How to use:
1. Surface treatment:Grinding or sand blasting to clean up the
dust,greasy dirt and rust on the surface of adherend,finally clean
it by cleaning agent and dry it by airing
2. Configure adhesive:According to the mass ratio A:B=2:1,make A
and B two component mix uniformly,when the temperature is low in
winter,can preheat the A component first.
3. Using adhesive:Make the configured adhesive be coating on the
adherend surface uniformly,double spread will get the better
4. Curing:Initial curing for 2 hours at room temperature,full
curing for 24 hours,heat it up to the temperature of 80℃ and keep
this temperature for 2 hours,then do the post curing,in this
way,can get the higher strength(≥23MPa).When the temperature is
below 15℃,the curing speed of the adhesive layers is slow,the
curing is not complete,need heating it up to the temperature of
60~80℃ and keeping this temperature for 2 hours after the adhesive
layers initial curing(Bake it with the iodine tungsten lamp or heat
it with hair dryer etc. heating measures)
|BD241 high temperature ceramic adhesive physical mechanical
|color||physical state||density(g/cm3)||compressive strength(kg/cm2)|
|BD241 high temperature ceramic adhesive curing features table(test
|coating time limit(min)||curing time||-||working temperature(℃)||tensile strength(kg/cm2)|
1. This parameter is for laboratory conditions,due to the actual
working condition is more complex,suggest users do pretest
according to actual working condition
2. When the environment temperature is below 15℃,the curing time
will prolong,should take proper heating measure 3. When the
environment temperature is more than 25℃ or the mixing quantity is
too large,the curing speed will expedite,should properly shorten
the application time of coating after mixing.
1.Sealed storage in the cool and dry place,the warranty period is 1
2.Avoid placing it upside down,knocking against and transporting it
as a non-dangerous product during transportation.
Product packaging photo of BD241 anti wear abrasion high
temperature resistant epoxy ceramic adhesive: